Dinçel Drain Heater cables are designed to be installed inside pipes to drain water from defrost cooling equipment mounted in cold rooms.
They operate only during defrost cycles.
We recommend using a control device to ensure the long lifespan of these heaters.
Note: The most commonly used power rating is 50 W/m. Additionally, we advise using the 40 W/m range for plastic pipes.
These highly flexible drain heating cables are fast, safe, and very easy to use. Standard models or custom designs tailored to your needs overcome most of the problems you may face during installation. For more information, contact Dinçel Resistors now.
It is used to prevent water from freezing inside drainage lines. In industrial cooling units, it is wrapped around fan edges to melt the radiator. It can be used against all types of freezing in supermarket freezers, air conditioners, aquariums, and more.
All drain heaters are manufactured according to demand.
They are produced at the desired power based on our customers' requests.
They are manufactured at 50W/m according to international standards.
The hot zones vary according to demand, while the cold zone is 1 meter.
This is a thermostat-controlled model.
| GLASS FIBER DIAMETER (MM) | 1.1 |
| HEATING WIRE | CHROMIUM-NICKEL OR COPPER-NICKEL |
| HEATING WIRE DIAMETER (MM) | 0.05–0.08 |
| CABLE DIAMETER (MM) | 5x5 |
| COATING | SILICONE ELASTOMER |
| TEMPERATURE RESISTANCE RANGE (°C) | -60 to 180 |
| CABLE LENGTH RANGE (M) | 1–20 |
| POWER (W) | 15–50 |
| MAXIMUM VOLTAGE (V) | 500 |
| TOLERANCE VALUES | POWER ±10% LENGTH ±1% DIMENSIONS ±0.2 mm |
